cooler master hyper 212 evo install guide

Something the Hyper 212 EVO 2 has are slots around the heat pipes on every cooling fin. I believe this is one of the secrets that makes the 212 coolers special. Do this allows the heat pipes to directly get the heat from the CPU itself, thus removing the heat right away. The heat pipes have been machined down flat and smooth. The mounting bracket and heat pipe holder is made of aluminum while the heat pipes are copper and are exposed in the bracket. If you are looking to install the 212 EVO 2 into a smaller case we suggest that you always measure and check your setup before purchasing any air cooler. Note that this is a test for a short duration 90% of apps run at decent rather low temps say 65-70 deg C even at 100% cpu loads.Topping out at 155mm in height the Cooler Master Hyper 212 EVO 2 will easily fit in a standard ATX case. in other heavy very intense cpu heavy apps the low 70 (i've tried bitcoin mining via pooler's cpuminer ) is quite often seen. Temp1: +27.8☌ - this reflects the ambient temp I guess i'm kind of late in this reply but i've an 'older' haswell i7 4771 + Hyper 212X But if you were to buy the 212 X and add the Noctua fan the total spend would be $74 dollars, with nothing done to improve the mounting system. As an alternative the 212 fan could be replaced by the Noctua NF-F12 fitted to the U13S, from PC Case Gear this would cost $29. From PC Case Gear the Noctua cooler is $75. For example you could consider the Noctua NH-U12S which has a fan which would idle in the 350 to 450 rpm range and has a substantially better mounting system.

Spending more money would get you both a better fan and offer the prospect of an improved mount. The 212, in either model, is a budget cooler and apart from the fan this also shows in the mounting system it uses, which in a word is poor and makes fitting far from easy.

The main issue with either fan is that idle speeds are likely to be around 600 to 700 rpm depending on system load and/or ambient temperatures. So, is the improved fan on the 212X good enough that it won't need to be replaced?.Both fans have around the same speed range, nominally 600 to 2000 rpm. Kreed wrote.If I go with the cheaper 212 EVO, I assume I would need to replace the fan with a better one.

Cooler master hyper 212 evo install guide